Mazda 6 2002, Workshop Manual

Page: 925 / 1248

EXTERIOR LIGHTING SYSTEM
T–31
T
HEADLIGHT ZEROSET
A6E811251030W05
Note
•
When the configuration is not set for the auto leveling control unit, headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the
SST (WDS or equivalent) to the DLC-2.
4. Turn the ignition switch to ON position.
5. Turn on the headlights (low-beam).
6. Input the vehicle information following the directions on the screen.
7. Confirm that the WDS or equivalent identifies the vehicle, and select “Datelogger”.
8. After the screen appears, select “LHID” under “Modules” from the cascading menu.
9. After the next screen appears, select “CALAXLSN#”.
10. On the graphic display that appears, press the
icon near the top right of the screen indicated by a
1 in the figure.
11. After the next screen appears, press the icon
indicated by a 2 in the figure.
12. After pressing the icon indicated by the 2, press
the icon indicated by a 3 or 4 in the figure to
execute the zeroset setting.
Note
•
Pressing an icon indicated by 3 or 4 once
will execute the headlight zeroset setting.
13. After executing the headlight zeroset setting,
perform an on-board diagnostic test and verify
that no DTCs are displayed.
14. Perform the headlight aiming adjustment. (See T–
26 HEADLIGHT AIMING )
End Of Sie
A6E8112W158
A6E8112W159