Mazda 6 2002, Workshop Manual

Page: 20 / 1248

FUNDAMENTAL PROCEDURES, INSTALLATION OF RADIO SYSTEM
GI–17
GI
DYNAMOMETER
A6E201400004W17
•
When inspecting and servicing the power train on the dynamometer or speed meter tester, pay attention to the
following:
— Place a fan, preferably a vehicle-speed proportional type, in front of the vehicle.
— Make sure the vehicle is in a facility with an exhaust gas ventilation system.
— Since the rear bumper might deform from the heat, cool the rear with a fan. (Surface of the bumper must be
below 70 degrees .)
— Keep the area around the vehicle uncluttered so that heat does not build up.
— Watch the water temperature gauge and don’t overheat the engine.
— Avoid added load to the engine and maintain normal driving conditions as much as possible.
Note
•
When only the front wheels are being rotated on the dynamometer, the ABS warning light could illuminate.
If the ABS warning light illuminates, turn the ignition switch to the LOCK position, then turn it back to the
ON position, run the vehicle at
10km/h and check that the ABS warning light goes off. (In this case, a DTC
will be stored in the memory. To delete this data from the memory, follow the procedure for deleting DTCs
(ABS) from memory.) (See
P–6 PRECAUTION (BRAKES) ) to turn off the warning light.)
End Of Sie
SST
A6E201400004W18
•
Some Ford SST or equivalent are used as SSTs necessary for engine repair. Note that these SSTs are
marked with Ford SST numbers.
•
Note that a Ford SST number is written together with a corresponding Mazda SST number as shown below.
Example (section ST)
Example (except section ST)
End Of Sie
INSTALLATION OF RADIO SYSTEM
A6E201600005W01
If a radio system is installed improperly or if a high-powered type is used, the CIS and other systems may be
affected. When the vehicle is to be equipped with a radio, observe the following precautions:
•
Install the antenna at the farthest point from control modules.
•
Install the antenna feeder as far as possible from the control module harnesses.
•
Ensure that the antenna and feeder are properly adjusted.
•
Do not install a high-powered radio system.
End Of Sie
XME2014002
XME2014001
INSTALLATION OF RADIO SYSTEM