Mazda 6 2002, Workshop Manual

Page: 420 / 1248

AUTOMATIC TRANSAXLE
K–13
K
AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT
A6E561401030W04
Warning
•
When the transaxle and ATF are hot, they can badly burn you. Turn off the engine and wait until
they are cool before changing the ATF.
1. Remove the oil dipstick.
2. Remove the oil drain plug and washer.
3. Drain the ATF into a container.
4. Install a new washer and the drain plug.
Tightening torque
30—41 N·m {3.0—4.2 kgf·m, 22—30 ft·lbf}
5. Add the specified ATF until ATF level reaches
lower notch of dipstick type of ATF through the oil
filler tube.
ATF type
ATF M-V
6. Ensure that the ATF level is in the HOT range (65
°
C{149
°
F}).
•
Add ATF to the specified level as necessary.
End Of Sie
HOLD SWITCH INSPECTION
A6E561446030W01
Operating Inspection
1. Turn the ignition switch to ON (engine OFF).
2. Verify that the HOLD indicator light is not illuminated. Depress the HOLD switch and verify that the HOLD
indicator light illuminates.
•
If not as specified, inspect the terminal voltage of the HOLD switch.
Voltage Inspection
1. Remove the console.
2. Turn the ignition switch to ON (engine OFF).
3. Measure the voltage at the HOLD switch
connector.
•
If not as specified, inspect for continuity at the
HOLD switch.
A6E5614W005
HOLD switch
position
Connector terminal
C D
Normal B+ 0
Depressed 0 0
A6E5614W006