Mazda 6 2002, Workshop Manual

Page: 989 / 1248

AUDIO AND NAVIGATION SYSTEM
T–93
T
T BODY ELECTRICAL SYSTEM
ANTI-THEFT SYSTEM
A6E812466900W01
Alarm Conditions
•
If the anti-theft system protection has been activated, any one of the following conditions will trigger the system:
— Disconnected battery cable
— Discharged battery
— Disconnected audio unit connectors
•
If the system is triggered, the audio unit will then be inoperative when it is reconnected to a power source, and
“code” will flash on the display until the preselected code number is input. If the anti-theft system is triggered,
follow the procedures in “Canceling Anti-theft Operation” to reset the unit.
Setting the Code Number
Complete each step (Steps 1–3) within 10 seconds or the setting procedure will be canceled.
1. Turn the ignition switch to ACC position and then turn off the audio unit.
2. First press the AUTO-M button, then
simultaneously press channel button 6 for
approximately 2 seconds until “CODE” appears
on the display.
3. Press the AUTO-M button again, then
simultaneously press channel button 6 until bars
appear on the display.
4. Select a personal code number and record it
before inputting it. If the number is input and then
forgotten, it cannot be canceled, and if the unit is
disconnected again, the audio unit will be
inoperative.
5. Use channel buttons 1–4 to input the selected
code number. Press button 1 for the first digit, 2
for the second, 3 for the third, and 4 for the last
digit. Input the number
within 10 seconds . If the
display is deleted, repeat the procedure from Step
1.
Note
•
Perform Step 6 within 10 seconds after
Step 5.
AUDIO AND NAVIGATION SYSTEM
Operation Reference
Input code number to activate anti-theft system Setting the Code Number
Delete previous code number and set new number Canceling the Code Number
Resume audio unit operation after anti-theft system is triggered Canceling Anti-theft Operation
A6E8124W025
A6E8124W026
A6E8124W027