Mazda 6 2002, Workshop Manual

Page: 921 / 1248

EXTERIOR LIGHTING SYSTEM
T–27
T
6. Set the headlights 3 m {10 ft} from the wall.
7. While adjusting one headlight, mask the other.
8. Start the engine to charge the battery.
9. Turn on the lower-beam headlight.
10. Set the headlight leveling switch to 0 position.
11. Adjust the headlights by turning the adjusting
screws as shown in the figure. Loosen the screws
first, then tighten them.
Note
•
If the adjusting screws are tightened first,
then loosened, they will continue to loosen
when the vehicle is in motion and may cause
the headlights to become misaligned.
12. Turn the adjusting screws and adjust the
headlight so that the elbow point in the shaded
area in the figure.
High-beam
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Seat one person in the driver's seat.
4. Position the vehicle straight ahead and perpendicular to a wall.
A6E8112W157
A6E8112W125
A6E8112W134
A6E8112W135