Mazda 6 2002, Workshop Manual

Page: 1020 / 1248

T–124
AIR BAG SYSTEM
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light
illuminates for approximately 6 seconds and
then goes off.
•
If the air bag system warning light does not
operate in the manner described above, there
are malfunctions in the system. Inspect the
system using the on-board diagnostic function.
End Of Sie
SAS UNIT REMOVAL/INSTALLATION
A6E813057030W01
Warning
•
Handling the SAS unit improperly can accidentally deploy the air bag modules and pre-tensioner
seat belt, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before
handling the SAS unit. (See
T–117 SERVICE WARNINGS .)
Caution
•
When replacing the SAS unit, configuration procedure must be done before removing the SAS
unit. If configuration is not completed before removing the SAS unit, DTC B1921 will detected.
1. Configurate the SAS unit (when only replacing it). (See T–124 SAS UNIT CONFIGURATION .)
2. Turn the ignition switch to LOCK position.
3. Disconnect the negative battery cable and wait for
more than 1 minute .
4. Partially peel off the floor covering.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Turn the ignition switch to ON position.
8. Verify that the air bag system warning light
illuminates for approximately 6 seconds and
then goes off.
•
If the air bag system warning light does not
operate in the manner described above, there
are malfunctions in the system. Inspect the
system using the on-board diagnostic.
End Of Sie
SAS UNIT CONFIGURATION
A6E813057030W02
1. Connect the SST (WDS or equivalent) to the
DLC-2.
2. Input vehicle information following the directions
on the screen.
3. Select “Module programming”.
4. Select “Programmable module installation”.
5. Select the following items and perform
procedures according to directions on the screen.
Items
•
“RCM”
6. Retrieve DTCs by the SST (WDS or equivalent),
then verify that there is no DTC present.
•
If DTC is present, perform applicable DTC inspection.
End Of Sie
1 Bolt
2 Connector
3 Side air bag sensor
A6E8130W005
1 Bolt
2 Connector
3 SAS unit
A6E8130W006
DLC-2
A6E3970W002