Mazda 6 2002, Workshop Manual

Page: 834 / 1248

SLIDING SUNROOF
S–75
S
End Of Sie
GLASS PANEL ADJUSTMENT
A6E774069810W02
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
3. If not as specified, loosen the glass panel installation screws and reposition the glass panel.
Clearance
a: -0.8—1.2 mm {-0.032—0.047 in}
b: 0 mm {0 in}
4. Tighten the installation screws.
5. Insert a prepaid card between the weatherstrip
and the body of the vehicle. Verify that the sunroof
is shut tightly (there is resistance when the
prepaid card is moved).
•
If the sunroof is not shut tightly, readjust by
performing Steps 3 and 4.
End Of Sie
FRONT DRAIN HOSE REMOVAL
A6E774069920W01
1. Remove the headliner.
2. Disconnect the front drain hose from the sunroof frame.
3. Remove the front drain hose from the clips.
4. Pull the front drain hose into the room side.
5. Remove the front drain hose.
End Of Sie
FRONT DRAIN HOSE INSTALLATION
A6E774069920W02
Caution
•
If the front drain hose is pinched or bent anywhere, the water in the hose may not discharge and
enter the inside of the vehicle. During and after installation of the trims and the headliner, always
make sure there is no interference with the front drain hose. Fix any problem if found.
1. Apply soapy water to the front drain hose inserting area.
2. Insert one end (the wider end) of the front drain hose into the sunroof frame.
3. Install the front drain hose to the clips, parallel to the pillar and free of slack.
4. Insert the front drain hose joint into the hinge pillar inner hole.
5. Install the headliner.
A6E7740W007
A6E7740W008
A6E7740W009