Mazda 6 2002, Workshop Manual

Page: 829 / 1248

S–70
WINDOW GLASS
4. Working with another person, saw through the
sealant around the edge of the glass.
5. Remove the rear window glass.
6. Remove the pins from the glass.
7. Remove the rear window molding from the glass.
End Of Sie
REAR WINDOW GLASS INSTALLATION
A6E773863931W02
Caution
•
To prevent the sealant from cracking or the glass from being pushed out by air pressure if a door
is closed, open all of the windows and leave them open until the sealant has hardened.
1. Cut away the old sealant using a razor so that 1—2 mm {0.04—0.07 in} thickness of sealant remains around
the circumference of the frame.
Warning
•
Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
2. If the sealant has come off completely in any one place, apply some primer after degreasing, and allow it
approximately 30 minutes to dry. Then put on new sealant to create a 2 mm {0.08 in} layer.
3. Clean and degrease an approximately 50.0 mm {1.97 in} wide strip around the circumference of the glass
and the bonding area on the body.
4. Install the molding as shown in the figure.
A6E7738W021
A6E7738W025