Mazda 6 2002, Workshop Manual

Page: 401 / 1248

J–4
MANUAL TRANSAXLE
OIL SEAL (DIFFERENTIAL) REPLACEMENT
A6E511219240W01
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Drain the oil from the transaxle.
3. Remove the front wheels and splash shields.
4. Separate the drive shaft and joint shaft from the transaxle. (See
M–17 DRIVE SHAFT REMOVAL/
INSTALLATION .) (See M–12 JOINT SHAFT REMOVAL/INSTALLATION .)
5. Remove the oil seals using a screwdriver.
6. Using the SST and a hammer, tap each new oil
seal in evenly until the SST contacts the transaxle
case.
7. Coat the lip of each oil seal with transaxle oil.
8. Insert the drive shaft and joint shaft to the
transaxle. (See M–17 DRIVE SHAFT REMOVAL/
INSTALLATION .) (See M–12 JOINT SHAFT
REMOVAL/INSTALLATION .)
9. Install the wheels and splash shields.
10. Add the specified amount and type of oil. (See J–
3 TRANSAXLE OIL REPLACEMENT .)
End Of Sie
VEHICLE SPEEDOMETER SENSOR REMOVAL/INSTALLATION
A6E511217400W01
Without ABS
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner compornent. (See
F–10 INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
4. Disconnect the vehicle speedometer sensor connector.
5. Remove the vehicle speedometer sensor.
6. Apply transmission oil to a new O-ring and install it on a vehicle speedometer sensor.
7. Install the vehicle speedometer sensor.
Tightening torque
7.8—11.3 N·m
{80—115 kgf·cm, 57.6—83.3 in·lbf}
8. Connect the vehicle speedometer sensor connector.
9. Install the air cleaner compornent. (See
F–10 INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
10. Install the battery and battery tray.
11. Connect the negative battery cable.
End Of Sie
A6E5112W009
A6E5112W001