LG-Nortel IP LDK-20, Programming Manual

Page: 556 / 581

IP LDK-20 Programming Manual Quick ADMIN Programming table
540
PGM ITEM FLEX SUB ITEM RANGE DEFAULT REMARK
5 VMIB Announce 2
Repeat timer
000-999 000
(sec)
This is used to repeat VMIB announce 2
when the timer is expired. (000: Not
repeat).
6 VMIB Announce 2
Repeat E/D
ON / OFF OFF
This value is used to enable or disable
VMIB Announce 2 Repeat.
7 Overflow
Destination
STA #/HUNT#/
VMIB #/SYS SPD#
-
The call to a station in the group will
continue to route until answered or each
station in the group has been tried. The
call will remain at the last station in the
group or will be passed to this overflow
station/group/ VMIB/System Speed bin,
after overflow timer expiring. The overflow
timer can be set at ADMIN program 191 –
FLEX 8.
8 Overflow Timer 000-600 180
(sec)
If this timer expires after a call is received
in the group, the call is routed to the
overflow destination.
The overflow destination can be set at
ADMIN program 191 – FLEX 7.
9 Wrap Up Timer 002-999 002
(sec)
A station in a hunt group is maintained in a
busy state during this timer value, after the
end of received call and outgoing call for
the assigned wrap-up time.
10 Music Source 0 - 8 00
If music source is assigned, calling user
will be heard music instead of ring back
tone.
11 Max. Queued Call
Count
00-99 99
This value is the maximum call count that
can be queued.
If the total queued call count is this value,
the next queuing tried call will be
disconnected.
Ring
Group
12 Supervisor STA # -
This value is used to set the supervisor
station.
1 Wrap-up Timer 002-999
(3 digits)
002
(sec)
A station in a hunt group is maintained in a
busy state during this timer value, after the
end of received call and outgoing call for
the assigned wrap-up time.
2 Put Mail Index 1-4 1
This index is one of the voice mail dialing
tables
3 Get Mail Index 1-4 2
This index is one of the voice mail dialing
tables
4 Hunt Type Cir/Term Term
This value is used to set the hunt type of
the VM member.
191
VM
Group
5 SMDI Port 01-10 01(COM1) This value is used to set SMDI print port.
SMDI is defined ‘Simplified Message Desk
Interface’ that indicates the distribute
information of VM.