LG-Nortel IP LDK-20, Programming Manual

Page: 252 / 581

IP LDK-20 Programming Manual System Basic ADMIN programming
236
3.6 Pre-programming
This section describes the pre-programming of the data. When installed, user must program some
database (Ex. Nationality, Numbering Plan Type, and Slot Assignment) first, otherwise system may not
operate properly.
Nation code (PGM 100)
Default Nation code : 82(Korea)
If you want to change nationality of the system, then use
ADMIN 100 .
*Note : When changing nation code, all data is initialized.
Numbering Plan (PGM 104/105/106/107)
Station number, a cipher of CO line, each feature codes at IP LDK System are assigned for default
value. User can change Station number, a cipher of CO line(2~4 figures), feature codes to appropriate
to user circumstance.
Feature codes of the system can be assigned flexibly via the system programming. Feature Code
length should be in the range of 1(one) digit through 4 digits. Let's say that a feature code conflict has
occurred in such case that a feature code string matches with other longer feature code string,
checking from
the first digit of the code. For example, features Code 53 and 536 have a feature code
conflict. The system will not allow any feature code conflict
* Note : If you change the numbering plan type at ADMIN 104, you have to reload flexible number plan
– Station number (PGM105) information. If you don’t reload that information, you would find some
mis-operation in checking the range.
IP setting for MPB (PGM 108)
IP address, Subnet mask, and Gateway address should be programmed for trace, remote upgrade,
PC ADMIN, PC Attendant, etc via network.
PROCEDURE FOR PRE-PROGRAMMING
1. Set DIP switch 4 as ‘ON’
2. Set Nationality (See Section 3.6), and reset the system (PGM 450–FLEX 15). Then slot
assignment is configured.
3. Set DIP switch 4 as ‘OFF’ to retain current configuration.
4. Set Numbering Plan Type. (See Section 3.6.5)
5. Set Flexible Numbering Plan. (See Section 3.6.6)