IP LDK-20 Programming Manual System Feature
10
Section 2. System Feature
2.1 How to get incoming call
2.1.1 Ring Assignment
Description
If there is an incoming call through CO Line which is ring assigned, the pre-assigned destination gets
the call. The destination can be Station, Hunt Group(see Ref.1), or VMIB announcement(see Ref.2).
If a destination station is busy, the incoming call gives muted ring signal, so the station user can
notice the incoming CO Call.
Following Figure 2.1.1 describes the Ring Assignment of incoming CO call. The ring can be assigned
to stations, hunt group or VMIB announcement.
Operation
Example
Make Station 100 ~ 105 ring at the incoming call from CO Line 1~8 at Day Mode, and station 110 start
to ring after 9 seconds.
1. Set CO Service type as Normal at ADMIN 140.
2. At ADMIN 144, select CO Line range 01~08 and press FLEX 1 (Day Mode)
3. Dial 1 (Station), and enter station range 100105.
4. To make the stations ring instantly, dial delay value 0 (without delay)
5. Save the changed setting by pressing [HOLD/SAVE] button.
6. Press FLEX 1(Day Mode) again without exiting ADMIN 144, and press 1 (Station) again.
7. Enter station range as 110110, and dial 3 as delay value. Save it again.
→
When there’s an incoming CO Call through CO Line 1 ~ 8 at Day mode, the station 100 ~ 105
starts to ring instantly. If one of the station answer the call, other stations stop to ring. After 9
seconds, if the call is still not answered, station 110 starts to ring.
Figure 2.1.1 Ring Assignment Destination
VMIB announcement
IP LDK System
Hunt Group
Station A
PSTN
Station B
Summary of Contents for IP LDK-20
