IP LDK-20 Programming Manual System Basic ADMIN programming
235
3.3 How to enter the programming mode
1. Lift handset or press the
[MON]
button on the ADMIN station, and hear ICM dial tone
(optional)
2. Press the
[TRANS/PGM]
button and dial
•
#
(Confirmation tone is heard)
•
Enter ADMIN password if the password has been set. This places the station into
the ADMIN programming mode (Confirmation tone is heard)
3. Each program is accessed by pressing the
[TRANS/PGM]
button and dialing the
three-digit program number. If an error is made while entering data, the
[TRANS/PGM]
button can go the previous status. When the
[TRANS/PGM]
button is
pressed, the LCD will display;
* NOTE :
1. The step 2, “[TRANS/PGM]
è
•
è
# ”,
is omitted from the procedure in
section 3 and section 4.
2. To return the parent state while ADMIN programming, press the [CONF]
button. Pressing the [CONF] button, temporary data fields are cleared.
3.4 Permanent update procedure
When the data has been entered, the [HOLD/SAVE] button is used to store the
data permanently.
If all data was entered correctly, confirmation tone is heard when pressing the
[HOLD/SAVE]
button.
If there were any errors in the entry, then an error tone is presented and data is not
stored in the permanent memory.
3.5 How to reset the system
To reset the system, enter PGM 450 – FLEX 15 and press [HOLD/SAVE] button. Or,
the system will be reset automatically after programming PGM100 – FLEX 1
(Nation Code Assign)
ENTER PGM NUMBER
Summary of Contents for IP LDK-20
