Lexmark Pro5500 Series, Service Manual

Page: 222 / 277

4-53
Service Manual
4447-20x
Go Back
Previous
Next
Disassembly
Flow chart
Encoder strip removal
Warning: Do not interchange screws during reinstallation, as it may damage the machine. Always take note of
their original placement.
1.
Remove the power supply. See “Power supply removal” on page 4-10 .
2.
Remove the duplex unit. See “Duplex unit removal” on page 4-11 .
3.
Remove the rear cover. See “Rear cover removal” on page 4-25 .
4.
Remove the left cover. See “Left cover removal” on page 4-26 .
5.
Remove the right cover. See “Right cover removal” on page 4-29 .
6.
Remove the control panel assembly. See “Control panel assembly removal” on page 4-35 .
7.
Remove the card reader. See “Card reader removal” on page 4-40 .
8.
Remove the ADF/scanner assembly. See “ADF/Scanner assembly removal” on page 4-42 .
9.
Remove the midframe cover. See “Midframe cover removal” on page 4-50 .
10.
Turn the gear clockwise, and move the printhead carrier assembly to the center of the printer.
Note: Take note of the following when moving the printhead carrier assembly:
•
Do not pull on the cables or tubes.
•
Place hands on the printhead carrier card shield to move the assembly.
11.
Raise the trap door on the ink mist cover to access the encoder strip attachment point.
12.
Press the leaf spring (A) to release the encoder strip from the right side.