Lenovo ThinkServer TD200, Hardware Maintenance Manual

Page: 32 / 346

Clearing the event logs
To clear the event logs, complete the following steps.
Note: The POST event log is automatically cleared each time the server is restarted.
Step 1. Turn on the server.
Step 2. When the prompt
<F1> Setup
is displayed, press F1. If you have set both a power-on password
and an administrator password, you must type the administrator password to view the event logs.
Step 3. Use one of the following procedures:
• To clear the IMM system-event log, select System Event Logs-->System Event Log . Select
Clear System Event Log ; then, press Enter twice.
POST error codes
The following table describes the POST error codes and suggested actions to correct the detected problems.
These errors can appear as severe, warning, or informational.
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 8 “Parts listing, TD200 Machine Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836” on page
257 to determine which components are customer replaceable units (CRU) and which components are
field replaceable units (FRU).
• If an action step is preceded by “(Trained service technician only),” that step must be performed only by
a trained service technician.
• Go to the Lenovo support Web site at http://www.lenovo.com/support/ to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Error code Description Action
0010002 Microprocessor not supported. 1. Reseat the following components one at a time, in
the order shown, restarting the server each time.
a. (Trained service technician only) Microprocessor
1.
b. (Trained service technician only) Microprocessor
2 (if installed.)
2. (Trained service technician only) Remove
microprocessor 2 and restart the server.
3. (Trained service technician only) Remove
microprocessor 1 and install microprocessor 2 in
the microprocessor 1 connector. Restart the server.
If the error is corrected, then microprocessor 1 is
bad and must be replaced.
4. Replace the following components one at a time, in
the order shown, restarting the server each time.
a. (Trained service technician only) Microprocessor
1.
b. (Trained service technician only) Microprocessor
2.
c. (Trained service technician only) System board.
24
ThinkServer TD200 Hardware Maintenance Manual