Lenovo ThinkServer TD200, Hardware Maintenance Manual

Page: 167 / 346

4
Front panel connector
15
SATA 0 (optical drive connector
5
Reserved
16
SATA 1
6
USB internal tape drive signal
cable connector
17
Reserved
7
Reserved
18
Battery
8
Front USB connector
19
PCI extender card connector
9
Reserved
20
Microprocessor 1
10
Hard disk drive backplane
configuration signal cable
connector
21
Virtual media key connector
11
Hard disk drive backplane
power cable connector
22
Power 2
Step 8. Remove the battery:
a. Use a finger to push the battery horizontally out of its socket, pushing it away from the
socket
1 .
b. Lift and remove the battery from the socket 2 .
Step 9. Dispose of the battery as required by local ordinances or regulations.
Installing the battery
The following notes describe information that you must consider when replacing the battery in the server.
• After you replace the battery, you must reconfigure the server and reset the system date and time.
• The lithium battery must be handled correctly to avoid possible danger. If you replace the battery, you
must adhere to the following instructions.
• You must replace the battery with a lithium battery of the same type from the same manufacturer.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only a battery recommended by the manufacturer. If your
system has a module containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or
disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Chapter 7
.
Installing and replacing FRUs
159