Lenovo ThinkServer TD200, Hardware Maintenance Manual

Page: 149 / 346

1
PCI Express Gen1 x8 (x4) slot
2
One-slot extender card
3
PCI slot error LED
Optional two-slot PCI extender card
The following is an illustration of the two-slot PCI extender cards that you can install to add two additional
PCI slots to the server.
1
PCI-X 32-bit/84-bit 133/100/66 MHz slots
2
Two-slot extender card
3
PCI slots error LEDs
Server power features
When the server is connected to an ac power source but is not turned on, the operating system does not
run, and all core logic except for the service processor (the Integrated Management Module) is shut down;
however, the server can respond to requests to the service processor, such as a remote request to turn on the
server. The power-on LED flashes to indicate that the server is connected to ac power but is not turned on.
Turning on the server
Approximately 5 seconds after the server is connected to ac power, one or more fans might start running
to provide cooling while the server is connected to power and the power-on button LED will blink quickly.
Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button becomes
active (the power-on LED will blink slowly). You can turn on the server by pressing the power-control button.
The server can also be turned on in any of the following ways:
• If a power failure occurs while the server is turned on, the server will restart automatically when power
is restored.
Chapter 6
.
Locating Server Controls and connectors
141