Krone Big Pack 1270, Original Operating Instructions, Page: 73 / 440

Initial operation 7
Adapting hydraulic system 7.7
BiG Pack 1270
Original Operating Instructions 150000747_02_en 73
ü
The machine has been connected to the tractor.
„ Remove the universal shaft.
„
Use a suitable auxiliary tool in order to support the intermediate bearing during the whole
adjustment process.
„
Remove the screws (2) of the intermediate bearing.
„
Move intermediate bearing (1) in the hole pattern.
„ Assemble the screws (2), tightening torque, refer to page 204 .
„
Install the universal shaft.
„ Check the bending angle of the universally-jointed drive shaft, refer to page 72 .
7.7 Adapting hydraulic system
For “Comfort 1.0” version
1
BPG000-018
„ Move the control units on the tractor into float position.
„
Depressurise the hydraulic system on the tractor and the machine.
„ Shut down and safeguard the machine, refer to page 27 .
Operation of the machine on tractors with constant flow system
For tractors with open hydraulic system.
„ Unscrew the system screw (1) as far as it will go.
Operation of the machine on tractors with Load Sensing system
For tractors with closed hydraulic system. In doing so, the signal line is connected.
„
Screw in the system screw (1) as far as it will go.
7.8 Setting the bale chute
When it is unfolded, the bale chute represents an extension of the bale channel. In order to
make sure that big bales are set down on the ground correctly, the back edge of the bale chute
must not be set too high above the ground. Otherwise the bales will be damaged when they are
placed on the ground.