22
Repairs, maintenance and settings by technicians
22.13 Setting the double knotter
322
BiG Pack 1270
Original Operating Instructions 150000747_02_en
ð
If the dimension is
not X=15–18 mm
, the blade lever must be aligned.
Carry out a visual inspection to ensure that the marked area (I) is smoothed and rounded.
ð
If this area (I) shows wear (formation of grooves), the blade lever must be exchanged.
BP000-204
Carry out a visual inspection to ensure that twine ends are not unequally cut or frayed.
ð
If twine ends are unequally cut or frayed, regrind the twine blades.
ð
If twine blades are broken or show too much wear, exchange twine blades.
Repeat this process for all blade levers and twine blades.
22.13
Setting the double knotter
WARNING
Danger to life due to unintentional triggering of the tying unit
If the tying process is not locked to facilitate maintenance, adjustment and repair work on the
knotter, the tying process may be triggered unintentionally. Thus, there is a risk of serious
injuries or death.
In order to facilitate maintenance, adjustment and repair work on the knotter, always
secure the knotter shaft with the safety lever to prevent unintentional triggering of tying
process.
The knotter has been set and controlled by the manufacturer. It should work properly without
requiring any further settings.
If there are problems with the tying process during initial operation:
Do not adjust the parts immediately.
Check whether the parts are affected by paint damages, rust or rough spots.
Æ
Deficiencies like paint damages, rust or rough spots must have to be rectified.
Check whether there is rust protection grease on the twine retainers and knotters.
ð
If there is rust protection grease, it must be eliminated from twine retainers and knotters.