Krone Big Pack 1270, Original Operating Instructions, Page: 349 / 440

Repairs, maintenance and settings by technicians 22
Checking/setting sensor B22 “Bale on table” 22.20
BiG Pack 1270
Original Operating Instructions 150000747_02_en 349
BP000-245
„ Press a bale (2) until ¾ of its length have exited the bale channel (1).
Æ
The signal sheet (3) does not cover the sensor (4).
Æ The sensor (4) is unattenuated (there is no iron in front of the sensor).
ü The machine is shut down and safeguarded, refer to page 27 .
„
Check dimension X, measured between the upper edge of the sensor (4) and the edge of
the signal sheet (3).
Æ
If the dimension is X=5 mm , the setting is correct.
Æ
If the dimension is not X=5 mm , the sensor must be set.
Setting
„
Loosen the nuts (5) on both sides of the sensor (4).
„ Push the sensor (4) upwards until dimension is X=5 mm between the upper edge of the
sensor (4) and the edge of the signal sheet (3).
„
Tighten the nuts (5) (tightening torque = 10 Nm).
„ During the sensor test, check that the sensor (4) is still unattenuated, refer to page 174 .
Æ
The sensor has been set correctly if the sensor test shows that the sensor is unattenuated.
Æ If the sensor test shows that the sensor is attenuated, adjust the sensor until the sensor test
shows that the sensor is unattenuated.
BP000-246