Kontron CP6923, Reference Manual, Page: 448 / 480

CP6923 FASTPATH log messages
Page B - 15 CP6923 CLI Reference Manual
Table 36: Linux BSP Log Message
Component Message Cause
Linux BSP rc = 10 Second message logged at bootup, right after
“Starting code…”. Always logged.
Table 37: OSAPI Linux Log Messages
Component Message Cause
OSAPI Linux osapiNetLinkNeighDump: could not open
socket! - or –
ipstkNdpFlush: could not open socket! – or –
osapiNetlinkDumpOpen: unable to bind
socket! errno = XX
Couldn’t open a “netlink” socket. Make sure
“ARP Daemon support” (CONFIG_ARPD) is
enabled in the Linux kernel, if the
BROADCOM reference kernel binary is not
being used.
OSAPI Linux ipstkNdpFlush: sending delete failed Failed when telling the kernel to delete a
neighbor table entry (the message is
incorrect)
OSAPI Linux unable to open /proc/net/ipv6/conf/default/
hop_limit
IPv6 MIB objects read, but /proc filesystem is
not mounted, or running kernel does not have
IPV6 support
OSAPI Linux osapimRouteEntryAdd, errno XX adding 0xYY
to ZZ – or –
osapimRouteEntryDelete, errno XX deleting
0xYY from ZZ
Error adding or deleting an IPv4 route (listed in
hex as YY), on the interface with Linux name
ZZ Error code can be looked up in errno.h.
OSAPI Linux l3intfAddRoute: Failed to Add Route – or –
l3intfDeleteRoute: Failed to Delete Route Error adding or deleting a default gateway in
the kernel’s routing table (the function is really
osapiRawMRouteAdd()/Delete())
OSAPI Linux osapiNetIfConfig: ioctl on XX failed: addr:
0xYY, err: ZZ – or –
osapiNetIPSet: ioctl on XX failed: addr:
0x%YY
Failed trying to set the IP address (in hex as
YY) of the interface with Linux name XX, and
the interface does not exist. Sometimes this is
a harmless race condition (e.g. we try to set
address 0 when DHCPing on the network port
(dtl0) at bootup, before it’s created using
TAP).
OSAPI Linux ping: sendto error Trouble sending an ICMP echo request
packet for the UI ‘ping’ command. Maybe
there was no route to that network.
OSAPI Linux Failed to Create Interface Out of memory at system initialization time.
OSAPI Linux TAP Unable to open XX The /dev/tap file is missing, or, if not using the
BRPOADCOM reference kernel binary, the
kernel is missing “Universal TUN/TAP device
driver support” (CONFIG_TUN).
OSAPI Linux Tap monitor task is spinning on select failures
– then –
Tap monitor select failed: XX
Trouble reading the /dev/tap device, check the
error message XX for details.
OSAPI Linux Log_Init: log file error - creating new log file This pertains to the “event log” persistent file
in flash. Either it did not exist, or had a bad
checksum.
OSAPI Linux Log_Init: Flash (event) log full; erasing Event log file has been cleared; happens at
boot time.
OSAPI Linux Log_Init: Corrupt event log; erasing Event log file had a non-blank entry after a
blank entry; therefore, something was messed
up.