Kontron CP6923, Reference Manual, Page: 258 / 480

Routing Commands CP6923
CP6923 CLI Reference Manual Page 4 - 46
4.8.51 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both parameters is 0-65535
seconds.
4.8.52 trapflags (OSPF)
Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or enable all the trap flags
at a time. The different groups of trapflags, and each group’s specific trapflags to enable or disable, are listed in
Table 1 .
Table 1: Trapflags Groups
• To enable the individual flag, enter the
group name
followed by that particular flag.
• To enable all the flags in that group, give the group name followed by
all
.
• To enable all the flags, give the command as
trapflags all
.
Default • delay-time—5
• hold-time—10
Format
timers spf <delay-time> <hold-time>
Mode Router OSPF Config
Group Flags
errors • authentication-failure
• bad-packet
• config-error
• virt-authentication-failure
• virt-bad-packet
• virt-config-error
if-rx ir-rx-packet
lsa • lsa-maxage
• lsa-originate
overflow • lsdb-overflow
• lsdb-approaching-overflow
retransmit • packets
• virt-packets
rtb • rtb-entry-info
state-change • if-state-change
• neighbor-state-change
• virtif-state-change
• virtneighbor-state-change
Default disabled