Kontron CP6923, Reference Manual, Page: 259 / 480

CP6923 Routing Commands
Page 4 - 47 CP6923 CLI Reference Manual
4.8.52.1 no trapflags
Use this command to revert to the default reference bandwidth.
• To disable the individual flag, enter the
group name
followed by that particular flag.
• To disable all the flags in that group, give the group name followed by
all
.
• To disable all the flags, give the command as
trapflags all
.
4.8.53 show ip ospf
This command displays information relevant to the OSPF router.
Format
trapflags {
all |
errors
{all | authentication-failure | bad-packet | config-error | virt-
authentication-failure | virt-bad-packet | virt-config-error} |
if-rx {all | if-rx-packet} |
lsa {all | lsa-maxage | lsa-originate} |
overflow {all | lsdb-overflow | lsdb-approaching-overflow} |
retransmit {all | packets | virt-packets} |
rtb {all, rtb-entry-info} |
state-change {all | if-state-change | neighbor-state-change | virtif-
state-
change | virtneighbor-state-change}
}
Mode Router OSPF Config
Format
no trapflags {
all |
errors
{all | authentication-failure | bad-packet | config-error | virt-
authentication-failure | virt-bad-packet | virt-config-error} |
if-rx {all | if-rx-packet} |
lsa {all | lsa-maxage | lsa-originate} |
overflow {all | lsdb-overflow | lsdb-approaching-overflow} |
retransmit {all | packets | virt-packets} |
rtb {all, rtb-entry-info} |
state-change {all | if-state-change | neighbor-state-change | virtif-
state-
change | virtneighbor-state-change}
}
Mode Router OSPF Config
Format
show ip ospf
Mode Privileged EXEC
Note: Some of the information below displays only if you enable OSPF and configure certain features.