Kontron CP6923, Reference Manual, Page: 206 / 480

Quality of Service (QoS) Commands CP6923
CP6923 CLI Reference Manual Page 3 - 32
The assign-queue parameter allows specification of a particular hardware queue for handling traffic that matches
this rule. The allowed
<queue-id>
value is 0-(n-1), where n is the number of user configurable queues available
for the hardware platform. The
assign-queue
parameter is valid only for a
permit
rule.
3.8.5 ip access-group
This command either attaches a specific IP ACL identified by
<accesslistnumber>
to an interface or associates
with a VLAN ID in a given direction. The parameter
<name>
is the name of the Access Control List.
An optional sequence number may be specified to indicate the order of this IP access list relative to other IP access
lists already assigned to this interface and direction. A lower number indicates higher precedence order. If a
sequence number is already in use for this interface and direction, the specified access list replaces the currently
attached IP access list using that sequence number. If the sequence number is not specified for this command, a
sequence number that is one greater than the highest sequence number currently in use for this interface and
direction is used.
3.8.5.1 no ip access-group
This command removes a specified IP ACL from an interface.
3.8.6 acl-trapflags
This command enables the ACL trap mode.
Format
{deny | permit} {every | {{icmp | igmp | ip | tcp | udp | <number>} <srcip>
<srcmask>[{eq {<portkey> | <0-65535>} <dstip> <dstmask> [{eq
{<portkey>| <0-65535>}] [precedence <precedence> | tos <tos> <tosmask> |
dscp <dscp>] [log] [assign-queue <queue-id>] [{mirror | redirect} <unit/
slot/port>]
Mode Ipv4-Access-List Config
Note: You should be aware that the <
out
> option may or may not be available, depending on the
platform.
Default none
Format
ip access-group <accesslistnumber> <name> [vlan <vlan-id>] <in |
out> [sequence <1-4294967295>]
Modes • Interface Config
• Global Config
Default none
Format
no ip access-group <accesslistnumber> [vlan <vlan-id>] in
Mode • Interface Config
• Global Config
Default disabled
Format
acl-trapflags
Mode Global Config