Kontron CP6923, Reference Manual, Page: 321 / 480

CP6923 Utility Commands
Page 6 - 7 CP6923 CLI Reference Manual
6.3.5 set board ipmi-controller debug
This command configures IPMI controller debug output. The command enables/disables temporary IPMI controller
serial debug output on the management serial console. Use with care as it may render the console useless until a
full board reset is executed.
6.3.6 set board pm-mode
This command sets the operational mode of the PM (Peripheral Manager).
6.3.7 set board sfp
This command sets control information for a specified SFP via CPLD register.
•
rate: set high or reduced bandwith
6.3.8 set board time
This command sets the local time of the board. The format string is the same as for the Unix date command
(<month><day> <hours><minutes><Century><Year>.<seconds>).
6.4 System Information and Statistics Commands
This section describes the commands you use to view information about system features, components, and
configurations.
6.4.1 show arp switch
This command displays the contents of the IP stack’s Address Resolution Protocol (ARP) table. The IP stack only
learns ARP entries associated with the management interfaces - network or service ports. ARP entries associated
with routing interfaces are not listed.
Format
set board ipmi-controller debug {on | off}
Mode Priviledged EXEC
Format
set board pm-mode {satellite | bmc}
Mode Priviledged EXEC
Format
set board sfp <slot/port> rate {high | reduce}
Mode Priviledged EXEC
Format
set board time <MMDDhhmmCCYY.ss>
Mode Priviledged EXEC
Format
show arp switch
Mode Privileged EXEC
Term Definition
IP Address IP address of the management interface or another device on the management network.
MAC Address Hardware MAC address of that device.