Kontron CP6923, Reference Manual, Page: 105 / 480

CP6923 Switching Commands
Page 2 - 61 CP6923 CLI Reference Manual
Example: The following shows an example of part of the CLI display output for the command.
(Ethernet Fabric) #show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- -------- ------- -------- ------- --------
0/1 Disable 5% Disable 5% Disable 5%
0/2 Disable 5% Disable 5% Disable 5%
0/3 Disable 5% Disable 5% Disable 5%
0/4 Disable 5% Disable 5% Disable 5%
0/5 Disable 5% Disable 5% Disable 5%
2.13 Port-Channel/LAG (802.3ad) Commands
This section describes the commands you use to configure port-channels, which are also known as link aggregation
groups (LAGs). Link aggregation allows you to combine multiple full-duplex Ethernet links into a single logical link.
Network devices treat the aggregation as if it were a single link, which increases fault tolerance and provides load
sharing. The LAG feature initially load shares traffic based upon the source and destination MAC address.Assign
the port-channel (LAG) VLAN membership after you create a port-channel. If you do not assign VLAN membership,
the port-channel might become a member of the management VLAN which can result in learning and switching
issues.
A port-channel (LAG) interface can be either static or dynamic, but not both. All members of a port channel must
participate in the same protocols.) A static port-channel interface does not require a partner system to be able to
aggregate its member ports.
2.13.1 port-channel
This command configures a new port-channel (LAG) and generates a logical slot/port number for the port-channel.
The
<name>
field is a character string which allows the dash “-” character as well as alphanumeric characters. Use
the
show port channel
command to display the slot/port number for the logical interface.
2.13.1.1 no port-channel
This command deletes a port-channel (LAG).
Note: If you configure the maximum number of dynamic port-channels (LAGs) that your platform
supports, additional port-channels that you configure are automatically static.
Note: Before you include a port in a port-channel, set the port physical mode. For more information, see
2.1.11 “speed” on page 2 - 6.
Format
port-channel <name>
Mode Global Config
Format
no port-channel {<logical slot/port> | all}
Mode Global Config