Kontron CP6923, Reference Manual, Page: 104 / 480

Switching Commands CP6923
CP6923 CLI Reference Manual Page 2 - 60
2.12.21 show storm-control flowcontrol
This command displays the flow-control configuration. The command displays the “flow-fanin” and “flow-percent”
value. The value currently in use and (if configured) the value configured (in paranthesis) are shown. Note that the
enable/disable flow-control mode is shown using “show storm-control” without arguments..
2.12.22 show storm-control
This command displays switch configuration information. If you do not use any of the optional parameters, this
command displays global storm control configuration parameters:
• Broadcast Storm Recovery Mode may be enabled or disabled. The factory default is disabled.
• 802.3x Flow Control Mode may be enabled or disabled. The factory default is disabled.
Use the all keyword to display the per-port configuration parameters for all interfaces, or specify the slot/port
to display information about a specific interface.
Example: The following shows example CLI display output for the command.
(Ethernet Fabric) #show storm-control
802.3x Flow Control Mode....................... Disable
Example: The following shows example CLI display output for the command.
(Ethernet Fabric) #show storm-control 0/1
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- -------- ------- -------- ------- --------
0/1 Disable 5% Disable 5% Disable 5%
Format
no storm-control flowcontrol
no storm-control flowcontrol flow-fanin
no storm-control flowcontrol flow-percent
Mode Global Config
Format
show storm-control flow-control
Mode Privileged EXEC
Format
show storm-control [all | <slot/port>]
Mode Privileged EXEC
Term Definition
Bcast Mode Shows whether the broadcast storm control mode is enabled or disabled. The factory default
is disabled.
Bcast Level The broadcast storm control level.
Mcast Mode Shows whether the multicast storm control mode is enabled or disabled.
Mcast Level The multicast storm control level.
Ucast Mode Shows whether the Unknown Unicast or DLF (Destination Lookup Failure) storm control mode
is enabled or disabled.
Ucast Level The Unknown Unicast or DLF (Destination Lookup Failure) storm control level.