Kontron CP6923, Reference Manual, Page: 407 / 480

CP6923 Management Commands
Page 7 - 21 CP6923 CLI Reference Manual
7.8 SNMP Commands
This section describes the commands you use to configure Simple Network Management Protocol (SNMP) on the
switch. You can configure the switch to act as an SNMP agent so that it can communicate with SNMP managers on
your network.
7.8.1 snmp-server
This command sets the name and the physical location of the switch, and the organization responsible for the
network. The range for
<name>
,
<loc>
and
<con>
is from 1 to 31 alphanumeric characters.
7.8.2 snmp-server community
This command adds (and names) a new SNMP community. A community
<name>
is a name associated with the
switch and with a set of SNMP managers that manage it with a specified privileged level. The length of
<name>
can
be up to 16 case-sensitive characters.
7.8.2.1 no snmp-server community
This command removes this community name from the table. The
<name>
is the community name to be deleted.
7.8.3 snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated community SNMP
packet sending address and is used along with the client IP mask value to denote a range of IP addresses from
which SNMP clients may use that community to access the device. A value of 0.0.0.0 allows access from any IP
address. Otherwise, this value is ANDed with the mask to determine the range of allowed client IP addresses. The
name is the applicable community name.
Default none
Format
snmp-server {sysname <name> | location <loc> | contact <con>}
Mode Global Config
Note: Community names in the SNMP Community Table must be unique. When making multiple entries
using the same community name, the first entry is kept and processed and all duplicate entries are
ignored.
Default • Public and private, which you can rename.
• Default values for the remaining four community names are blank.
Format
snmp-server community <name>
Mode Global Config
Format
no snmp-server community <name>
Mode Global Config
Default 0.0.0.0
Format
snmp-server community ipaddr <ipaddr> <name>
Mode Global Config