Kontron CP6923, Reference Manual, Page: 132 / 480

Switching Commands CP6923
CP6923 CLI Reference Manual Page 2 - 88
2.17.4.1 no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
2.17.5 ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface. Configuring none for the limit
means the interface is not rate limited for Dynamic ARP Inspections.
2.17.5.1 no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default values of 15 pps and
1 second, respectively.
2.17.6 ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of comma-separated VLAN
ranges. If the static keyword is given, packets that do not match a permit statement are dropped without consulting
the DHCP snooping bindings.
2.17.6.1 no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of comma-separated
VLAN ranges.
Format
no ip arp inspection trust
Mode Interface Config
Note: The user interface will accept a rate limit for a trusted interface, but the limit will not be enforced
unless the interface is configured to be untrusted.
Default
15 pps for rate and 1 second for burst-interval
Format
ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode Interface Config
Format
no ip arp inspection limit
Mode Interface Config
Default
No ARP ACL is configured on a VLAN
Format
ip arp inspection filter acl-name vlan vlan-list [static]
Mode Global Config
Format
no ip arp inspection filter acl-name vlan vlan-list [static]
Mode Global Config