Kontron CP6923, Reference Manual, Page: 317 / 480

CP6923 Utility Commands
Page 6 - 3 CP6923 CLI Reference Manual
6.1.3 download frudata
This command restores the factory defaults for the FRU data.
6.1.4 download fwum
This command updates the FWUM firmware. It downloads an FWUM firmware image from URL and flashes the
FWUM with the new image. If the flash process is interrupted or fails, the FWUM will not recover gracefully and the
board has to be repaired manually.
Use this command with extreme care. It is not field safe.
Do not interrupt the upgrade process.
6.1.5 download bootloader
This command loads a bootloader image. It downloades a bootloader image from URL into the second partition.
This image is used for next booting. If the download fails or the image is not correct (CRC error), the image in the
first partition is used.
6.1.6 startupslot
This command configures the startup slot with the supplied values from the other slots. It will also check the
configuration for consistency and flag any errors. The slot number (<slotnumber>) ranges from 1 - 9.
6.1.7 startupslot activate
This command sets the startup slot to active and will use this in all subsequent reboots. Using [once] at the end of
the command will set the startup slot to be used once during the next restart. The start sequence will reset the startup
slot to the previously installed one. This enables a try-once with automatic rollback in case of error.
Format
download frudata factory-default
Mode Priviledged EXEC
Format
download fwum <url>
Mode Priviledged EXEC
Format
download bootloader <url>
Mode Priviledged EXEC
Format
startupslot <slotnumber> config {F | <1..99>} initrd {A | B}
Mode Global Config
Format
startupslot <slotnumber> activate [once]
Mode Global Config