Kontron CP6923, Reference Manual, Page: 252 / 480

Routing Commands CP6923
CP6923 CLI Reference Manual Page 4 - 40
4.8.34 distribute-list out (OSPF)
Use this command to specify the access list to filter routes received from the source protocol.
4.8.34.1 no distribute-list out
Use this command to specify the access list to filter routes received from the source protocol.
4.8.35 exit-overflow-interval (OSPF)
This command configures the exit overflow interval for OSPF. It describes the number of seconds after entering
overflow state that a router will wait before attempting to leave the overflow state. This allows the router to again
originate non-default AS-external-LSAs. When set to 0, the router will not leave overflow state until restarted. The
range for seconds is 0 to 2147483647 seconds.
4.8.35.1 no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
4.8.36 external-lsdb-limit (OSPF)
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no limit. When the
number of non-default AS-external-LSAs in a router's link-state database reaches the external LSDB limit, the router
enters overflow state. The router never holds more than the external LSDB limit non-default AS-external-LSAs in it
database. The external LSDB limit MUST be set identically in all routers attached to the OSPF backbone and/or any
regular OSPF area. The range for limit is -1 to 2147483647.
4.8.36.1 no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
distribute-list <1-199> out {rip | bgp | static | connected}
Mode Router OSPF Config
Format
no distribute-list <1-199> out {rip | bgp | static | connected}
Mode Router OSPF Config
Default 0
Format
exit-overflow-interval <seconds>
Mode Router OSPF Config
Format
no exit-overflow-interval
Mode Router OSPF Config
Default -1
Format
external-lsdb-limit <limit>
Mode Router OSPF Config
Format
no external-lsdb-limit
Mode Router OSPF Config