Kendro HERAcell 150, Operating Instructions Manual

Page: 205 / 251

Gas Tight Screen for the HERAcell
®
and HERAcell
®
150, Retrofit
Version: 07.2003 / 50078424
12
3.6 Configuration control- and rule system (softwareversion 210)
Beside the installation of the gas tight
screen you have to configure the
appropiate set of parameters.
Enter funktion level 21 and choose
the right set of the parameters.
Information:
After switching on the incubator,
tha actual set of the parameters is
indicated during the start routine.
Upper display:
Pr
Lower display: Parameter
General description Input
1. To access the function levels
simultaneously press the cal – key, the
i – key, and the auto-start – key, and
hold them down for at least 5 seconds.
The programm enters function level 0.
2. To move to the various function levels,
press and hold down the cal – key and
use the - key.
Go to function level 21.
3. To access a particular sublevel, press
and release the cal – key until you
rech the desired sublevel.
1.
2.
3.
Enter sublevel 2.
See chart 1 function level 21.
Press the cal and - key, set
value 1.
(Set of parameters unlocked)
Enter sublevel 4.
Press the cal and - key, set
value 1.
Enter sublevel 10.
Press the cal and - key, set
value 1. (writing EPROM)
4. After changing the set of parameters
the unit restarts. If nothing has been
changed continue with 4.1.
4.1 To exit the function level:
- Press the C – key or the
. % CO
2
– key or
– wait 5 seconds without pressing
. a key.