Kendro HERAcell 150, Operating Instructions Manual

Page: 118 / 251

Name/Name Datum/Date Benennung/Designation
Erstellt/Prepared
D.Dornseiff 01/15/98
Index Änderung Name/Name Datum/Date
Service Handbuch HERAcell 150
Service Manual HERAcell 150
C 202613 D.Dornseiff 06/26/03
Dokumentnr./Document No. Seite/Page
Datei/File
50051109_04_EN_C.doc 50051109 / C 12/ 9
Weitergabe sowie Vervielfältigung dieser Unterlage, Verwertung oder Mitteilung ihres Inhalts nicht gestattet, soweit nicht ausdrücklich zugestanden. Zuwiderhandlungen ver-
pflichten zu Schadensersatz. Alle Rechte für den Fall der Patenterteilung oder Gebrauchsmustereintragung vorbehalten. © Kendro Laboratory Products GmbH, Germany
4.5 CONTROL AND REGULATING SYSTEMS CONFIGURATION
NOTE:
Function levels FL 1 - FL 4 described below are only used to monitor the val-
ues entered here.
Normally, these values should only be changed by the fac-
tory adjustment .
Any required device calibrations can be performed with the aid of the
adjustment routine, initiated by the "cal" key (refer to the operating in-
structions)!
1) To access the function levels described below, simultaneously press the cal key,
the i key, and the auto-start key, and hold them down for at least 5 seconds. The
program enters function level 0.
2) To move between various function levels, press and hold down the cal key and
use the
/
keys.
3) To access a particular sublevel, press and release the cal key until you reach the
desired sublevel.
4) To modify a sublevel, press and hold down the cal key on the desired item, then
change its value with the
/
keys.
5) To exit a function level:
Press the C or the % CO
2
key.
Wait 30 sec. Without pressing another key.