Kendro HERAcell 150, Operating Instructions Manual

Page: 214 / 251

HERAcell
®
, HERAcell
®
150 and HERAcell
®
240, Main PCB Replacement
7
3.5 Configuration Settings
(units without any options, small control box)
The following appear when the device is switched on:
The green lamp incorporated the mains power switch lights up.
8-digit check of both displays, and all LEDs are on.
If High/Low humidity has been configured, the associated LED will also light
up during the 8-digit check.
The version of the current software will be displayed:
P 1 (display PCB): e.g., 004, that is, Version 4
P 2 (sensor PCB): e.g., 015, that is, Version 15
P 3 (main PCB): e.g., 202, that is, Version 202
Pr (parameter set) e.g.. 004, that is HERAcell, 120V, Cu
The device then displays the current actual values of temperature and CO
2
.
Next, select the appropriate parameter set for your unit from the table below:
Device assignment to the control parameter sets
Parameter set no. Device Note
1 HERAcell, 230 V, SS SS = stainless steel
2 HERAcell, 230 V, Cu
3 HERAcell, 120 V, SS SS = stainless steel
4 HERAcell, 120 V, Cu
5 HERAcell 240, 230 V, SS SS = stainless steel
6 HERAcell 240, 230 V, Cu
7 HERAcell 240, 120 V, SS SS = stainless steel
8 HERAcell 240, 120 V, Cu
9
10
11
12 HERAcell 240, 230 V, SS
HERAcell 240, 230 V, Cu
HERAcell 240, 120 V, SS
HERAcell 240, 120 V, Cu
Parameter sets 9 -12, booster
switched off for 6 door screen
Inputting the selected parameter set in function level 601, sublevel 1:
1) The function levels are accessed by simultaneously pressing and holding the cal - key,
the i - key, and the auto start - key for at least 5 sec. The program then jumps to function
level 0.
2) Holding down the cal - key and pressing the ? key will take you to function level 601.