Kendro HERAcell 150, Operating Instructions Manual

Page: 62 / 251

CO
2
Incubator HERAcell ® 150 Operating Instructions
62
9. Cleaning and disinfection
Final disinfection:
1 Install shelf system and accessories.
2. Again, spray disinfectant onto the surfaces of the work space and of the ac-
cessories or wipe the surfaces clean using disinfectant.
3. Allow disinfectant to react as speciefied by manufacturer.
9.3 ContraCon decontamination routine
CAUTION! – Hot surface!
The surfaces of the work space, particularly the
glass door armatures and the interior sheet of
the outer door, are heated during the decon-
tamination routine.
During the routine run or immediately after
completion of the run, always wear safety
gloves when touching these surfaces; observe
the warning indicator at the operating panel!
The entire program run of the decontamination routine takes approx 25 hours.
1. After the cleaning, reinstall the shelf system components into the work space.
2. Fill the water tray with 300 ml of processed water.
3. Turn the device on using the power switch.
4. Activate decontamination routine (see table in Section 9.4).
5. After the decontamination routine has been completed, remove the remai-
ning water using a sterile cloth.
6. Turn the device off or restart the device operation using auto-start
(see Section 7.2).
NOTE – Duration of the auto-start routine
When the device is cold and when the ambi-
ent temperature is low, the auto-start routine
may take up to 10 hours.