Kendro HERAcell 150, Operating Instructions Manual

Page: 40 / 251

CO
2
Incubator HERAcell ® 150 Operating Instructions
40
6. Handling and control
6.1 Power switch
Fig. 24: Depending on which side the door hinges are installed,
the power switch [1] is integral to the front cover [2] of one of
the front device stands.
• To turn the device on:
Press the power switch [1]; the switch illumination comes
on.
• To turn the device off:
Press the power switch; the switch illumination goes off.
6.2 Operating panel
Fig. 25: The operating panel is divided into three functional
areas:
• 3 displays that show numeric values for temperature, O
2
content, CO
2
content (fully equipped).
• 9 keys for selecting functions and for entering data (fully
equipped).
• 9 LEDs that show functions or operating states.
For devices without O
2
supply, the key for setting the O
2
no-
minal value and the O
2
display are not installed on the ope-
rating panel.
Fig. 24
Power switch
Fig. 25
Operating panel functions
[1] Temperature display
[2] Heating LED
[3] Key for setting temperature nominal value
[4] Key for setting O
2
nominal value
[5] Key for increasing value
[6] Key for reading failure codes/stopping acoustic
alarm
[7] Key for activating auto-start
[8] LED for indicating active auto-start
[9] LED for indicating door (open door)
[10] LED for indicating active ContraCon decontamina-
tion routine
[11] LED for indicating active low humidity
[12] LED for indicating low water level
[13] LED for indicating active overtemperature
protection
[14] Key for starting ContraCon decontamina-
tion routine
[15] Key for starting cal function
[16] Key for reducing value
[17] Key for setting CO
2
nominal value
[18] CO
2
display
[19] LED for indicating active CO
2
gas supply
[20] O
2
display
[21] LED for indicating active O
2
gas supply