Kendro HERAcell 150, Operating Instructions Manual

Page: 30 / 251

CO
2
Incubator HERAcell ® 150 Operating Instructions
30
Fig. 14
Shelf support/
sheet/insert installation
Fig. 15
Installing gas humidification
5. Start-up
Installing the shelf supports:
1. Fig. 14: Insert the shelf supports [3] into the perforations
[1] of the support rail with the bar facing down.
2. Make sure that the two vertical elements [2] of the shelf
support are flush with the support rail.
Installing the shelves:
1. Fig. 14: Push the shelf [4] onto the shelf supports with the
tilt protection [5] facing the rear panel of the device. The tilt
protection [5] is also used as a guide for the shelf.
2. Slightly raise shelf so that the withdrawal stop [6] can be
routed over the shelf supports.
3. Make sure that the shelf supports is positioned in the two
tilt protections in a way that it can move freely.
Levelling the device:
1. Position a bubble level onto the center shelf.
2. Rotate the adjustable device stands using the supplied 24
mm wrench until the shelf is positioned horizontally in all
directions. Perform the adjustment of the device stands from
left to right and from rear to front.
Installing the gas humidification (only for O
2
control):
Fig. 15: The gas humidification [10] is installed to the water
tray parallel to the rear panel of the device. The position to the
right side wall is predetermined by the hose length.
1. Install hose [8] to the sleeve [9] of the gas humidification
and then to the sleeve [7] of the device-integral oxygen or
nitrogen supply line.
2. Place gas humidification immediately to the rear panel of
the device.