Kendro HERAcell 150, Operating Instructions Manual

Page: 203 / 251

Gas Tight Screen for the HERAcell
®
and HERAcell
®
150, Retrofit
Version: 07.2003 / 50078424
10
3.5 Configuration control- and rule system (softwareversion < 202)
Beside the installation of the gas tight
screen you have to configure the
appropiate set of parameters.
Enter funktion level 601 and choose
the right set of the parameters.
Information:
After switching on the incubator,
the actual set of the parameters
is indicated during the start
routine.
Upper display:
Pr
Lower display: Parameter
General description Input
1. To access the function levels
simultaneously press the cal – key, the
i – key, and the auto-start – key, and
hold them down for at least 5 seconds.
The programm enters function level 0.
2. To move to the various function levels,
press and hold down the cal – key and
use the - key.
Go to function level 601.
3. To access a particular sublevel, press
and release the cal – key until you
rech the desired sublevel.
1.
2.
Enter sublevel 2.
See chart 1 function level 601.
Press the cal and - key. Set
value 1.
(Set of parameters unlocked)
Enter sublevel 1.
See chart 1 function level 601.
Enter the appropiate set of
parameters for the incubator,
press cal and -key see chart 2.
See example.
4. After changing the set of parameters
the unit restarts. If nothing has been
changed continue with 4.1.
4.1 To exit the function level:
- Press the C – key or the
. % CO
2
– key or
– wait 5 seconds without pressing
. a key.