Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 50 / 252

2-24
CHASSIS MODIFICATIONS D
AILY
Base — 02/2012 Printed 603.95.241
Application of the towing hook
Application of the towing hook
2.6 Application of the towing hook
2.6.1 Adjusting the vehicle for towing
The transformation from a non-towing version to an approved towing version is permitted without the specific need for
authorisation by IVECO.
A vehicle that is not originally setup for towing can be adjusted for this purpose by adding a specific ”towing section”, which means
inserting the assembly of components that are indicated in the type-approval documentation of the towing version (chassis cross
member, electrical coupling joint, towing hook, chronotachograph, etc...).
Please note that the assembly of the chronotachograph, based on current regulations, may only be performed by the IVECO service
Network.
2.6.2 Precautions for installation
The towing hook must be suitable for the permitted loads and must be type-approved by national standards.
!
Since it is an important element with regard to safety, the towing hook must not be modified.
When fastening the hook to the cross member, it is necessary to comply with the requirements of the hook manufacturer as well
as the limitations determined by current regulations (minimum spaces for the electrical system joint and brake joint, maximum
distance between the hook pin axle and rear edge of the superstructure, etc.).
If the hook attachment flange does not have drill holes suitable for the existing ones on the rear vehicle cross member, changing
the drill holes on the latter may be authorised after applying suitable reinforcements.
The fitter is obliged to create and install the superstructure in a manner that makes it possible to perform the necessary manoeuvres
and check the hook without obstacles or danger.
Freedom of movement must be guaranteed for the trailer drawbar.
2.6.3 Hook types
The types of available hooks are:
a) ball
b) pin (automatic)
Pin hooks may only be installed on the truck version and if a suitable cross member is used.
If not supplied directly by IVECO, both types must be type-approved in compliance with current standards.
Table 2.12 contains data for the towing hooks available on the production line.
Table 2.12 - Type-approved hooks
Type Class D (kN) D
C
(kN) V (kN) EC type-approval no.
GS500 A50-X 22.5 - 25.0 AND 11*94/20*0533*00
GA381 S 22.5 - 25.0 AND 11*94/20*1613*01