Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 15 / 252

GENERAL SPECIFICATIONS
1-7
D
AILY
Printed 603.95.241 Base - 02/2012
Prevention of accidents
Prevention of accidents
1.10 Prevention of accidents
Do no allow unauthorised personnel to work on or operate the vehicle.
It is forbidden to use the vehicle if its safety devices have been tampered with or damaged.
Structures and devices applied to the vehicles must conform to current requirements for accident
prevention and safety regulations in each Country where the vehicles are to be used.
All technical precautions must also be taken to avoid functional faults and defects.
Compliance with these regulations will be the responsibility of the manufacturers of the structures and devices.
!
Seats, upholstery, seals, protective panels etc. can represent a potential fire hazard if exposed to an
intense heat source.
Arrange for their removal before working with welding equipment and flames.
1.11 Choice of material to use: Ecology - Recycling
The choice of materials to be used must be carefully considered in the study and design phase also from an ecological and
recycling point of view.
In this regard, the following should be kept in mind:
- the use of materials which are damaging to health, or in any case potentially hazardous is forbidden, for example those containing
asbestos, lead, halogen additives, CFCs, cadmium, mercury, hexavalent chromium etc.;
- it is recommended to use materials which produce a limited quantity of waste when worked and which allow easy recycling
after their first use;
- mutually compatible components should be used for composite synthetic materials, also providing for potential use with salvaged
components. Arrange for markings required by current regulations;
- batteries contain substances which are very damaging to the environment. The Service Network can be contacted when
replacing batteries they are equipped for correct disposal of old batteries in full compliance with the law.
In order to comply with directive 2000/53 EC (ELVs), IVECO forbids installation of components
containing lead, mercury, cadmium and hexavalent chromium; exceptions are made for the cases
allowed for by Annex II of this directive.