Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 137 / 252

FITTING SUPERSCTRUCTURES
3-39
D
AILY
Printed 603.95.241 Base - 02/2012
Special body conversions
3.14.3 Installation of overhead platforms
The application of an overhead platform or basket must comply with national (e.g. CUNA, DIN) and international (e.g. ISO, CEN)
regulations, in addition to any specific limitations.
The choice of platform must be carried out by checking compatibility with the characteristics of the vehicle frame that is present.
Positioning on the vehicle must comply with the admissible load and distribution limits.
Exceptional cases must be assessed from time to time and specific authorisation must be obtained from IVECO.
The installation of an overhead platform/basket requires the introduction of a suitable counterframe. In addition to following the
general instructions, (see Chapter 3.3 and Table 3.2 and Table 3.3), the Fitter must also:
- assess the maximum static momentum and the envisaged position for the superstructure;
- avoid sudden section changes;
- realize a fastening solution as shown in Figure 3.2 on page 3.6 or, in the event of extreme mechanical stress, as shown in Figure
3.23.
Figure 3.23
INITIAL FASTENING OF THE COUNTERFRAME
173275
!
The Fitter must carry out all the necessary precautions to ensure correct use and the operational sta-
bility of the vehicle. In this context the type and number of stabilizers must be decided with the Manu-
facturer of the superstructure.
Hence the Fitter must also:
- adjust the raising/lowering speed of the vehicle on the stabilizers by means of the appropriate flow control valves in the hydraulic
system;
- indicate the requirement to limit, as much as possible (3-5 cm), raising the vehicle’s front axle off the ground, compatibly with
the condition of maintaining horizontal alignment.
Revi - 10/2012