Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 150 / 252

4-12
POWER TAKE OFFS D
AILY
Base - 02/2012 Printed 603.95.241
PTO management
d) For vehicles with an Expansion Module it is necessary to order the components for installation of the PTO, the cable for
connection of this to the engine compartment cable connector (1-fig. 4.7), the two relays (1-fig. 4.8) to install in the Expansion
Module (fig 4.8) and the PTO activation/deactivation request button (6-fig 4.6).
Figure 4.8
166054
Relay and fuse module for PTO with Expansion Module
Table 4.3
SCM1/C Power Protection
Presence
Capacity Type
EURO5
4x2
EUROV
4x2
BIFUEL
S OPT
F79 30 Expansion Module relay T61 (30-87) for PTO X 15 A0 X X X
F80 30 Expansion Module relay T62 (30-87) for PTO X 15 A0 X X X
F86 AVAILABLE A0
F88 AVAILABLE A0
F89 AVAILABLE A0
F90 AVAILABLE A0
SCM1/C Power Protection
Presence
Capacity Type
EURO5
4x2
EUROV
4x2
BIFUEL
S OPT
T61 Expansion Module X 20 X X X
T62 Expansion Module X 20 X X X
- With the PTO installed, the Engine Control Unit can be configured by IVECO service in order to
set the engine operating conditions with PTO engaged.
- If you wish to install a PTO after market, you must check whether the vehicle is fitted with Cruise
Control.
- The Expansion Module does not manage the tipper body. If a PTO is to be installed after market
for this use, the kit with PTO control panel must be purchased (kit for vehicles without Expansion
Module).
NOTE