Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 146 / 252

4-8
POWER TAKE OFFS D
AILY
Base - 02/2012 Printed 603.95.241
Power Take Off from transfer box
Power Take Off from transfer box
4.3 Power Take Off from transfer box
Not present on Daily 4x2. NOTE
4.4 Power Take Off from drive line
Authorisation of the installation of a PTO on the transmission after the gearbox will be given after examination of the complete
documentation which must be presented to IVECO.
The power and torque values are defined each time on the basis of the usage conditions.
As a general rule, bear in mind that:
- the PTO may only operate with the vehicle stationary;
- the Power Take Off r.p.m. is dependent on the gear selected;
- the installation must be performed immediately after the gearbox; for vehicles with transmissions of two or more shaft sections
the PTO may also be installed in correspondence with the oscillating mount between the first and second section (follow
indications in point 2.9.2);
- the original transmission angles in the horizontal and vertical planes must be maintained as closely as possible;
- anything added to the transmission must not cause abnormal vibrations or instability or otherwise damaging effects on the drive
transmission components (from the engine to axle) either during driving or use of the PTO;
- the PTO must be attached to the chassis with its own suspension system.
The transmission is a component that is important to vehicle driving safety. Any operations on the
transmission must be carried out only by highly specialised companies that have been approved by the
supplier.
!
Any operation carried out on the propeller shaft without obtaining previous authorisation from IVECO
will cause the vehicle warranty to immediately become null and void.
!