Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 18 / 252

1-10
GENERAL SPECIFICATIONS D
AILY
Base - 02/2012 Printed 603.95.241
Dimensions and masses
Dimensions and masses
1.15 Dimensions and masses
1.15.1 General specifications
The vehicle dimensions and permitted weights on the axles are shown on the drawings, on the technical descriptions and more
generally on the documents on the IVECO official website. The kerb weights refer to vehicles with standard equipment. Special
equipment may involve considerable modification to the weight and its distribution on the axles.
Weighing the chassis
It must be remembered that variations in mass of
±
5% for 29L, 35S, 35C models and
±
3% for 40C to 70C models are possible.
It is therefore, advisable to weigh the vehicle in the chassis cab condition before fitting the body and equipment and establish the
weight distribution on the axles.
Body conversions
The body building limits for each model are mainly defined by the following:
- weight distribution on the axles;
- width of the mirrors used;
- position of the rear under run-bar.
Greater values in compliance with the weights permitted on the axles may be authorized by IVECO after modifying such components
as the chassis, under run-bar, mirrors, etc.
Positioning of lights and side mirrors is normally expected for widths up to 2350 mm.