Iveco DAILY M.Y. 2012, Body Builder Instructions, Page: 143 / 252

POWER TAKE OFFS
4-5
D
AILY
Printed 603.95.241 Base - 02/2012
Power Take Off from gearbox
Power Take Off from gearbox
4.2 Power Take Off from gearbox
Take off from the transmission lay shaft is possible via flanges or couplings positioned in the left part of the casing (see fig. 4.3).
Table 4.1 lists the maximum torques and the output rpm to engine rpm ratios for the various transmission/IVECO optional PTO
combinations.
Any higher take-off torques, for occasional uses, must be individually authorised by IVECO on the basis of the type of use.
The PTO must normally be used with the vehicle parked and must be engaged and disengaged with the clutch disengaged to avoid
excessive stress on the synchronisers.
When, under exceptional circumstances, it is used with the vehicle in movement, no gear changes must be performed.
The same PTOs for manual gearboxes can be used with gearboxes fitted with torque converters.
It must, however, be remembered that for engine rpm of below 60% of the maximum, the converter works hydraulically and in this
stage the PTO rpm is subject to fluctuations depending on power draw, even if the engine rpm is constant.
Figure 4.3
166057
1. Cover for arranging Power Take Off
After the assembly of the Power Take Off perform the filling up and check the oil level from the speed
gearbox. NOTE