Iveco DAILY M.Y. 2012, Body Builder Instructions

Page: 144 / 252

4-6
POWER TAKE OFFS D
AILY
Base - 02/2012 Printed 603.95.241
Power Take Off from gearbox
Transmission PTO data
Post-production installation of a PTO requires reprogramming of the gearbox control unit (if automatic) as well as some work
on the electrical system. As such, it is recommended you read section 4.6 ”PTO management” before proceeding.
The control unit must be reprogrammed by following the instructions found in the relevant IVECO manuals, using the diagnostics
tool available from Dealers and Authorised Workshops and supplying information on the PTO used.
Table 4.1
Gearbox
Position
(1)
Output
(1)
Direction of
rotation (2)
Max. torque
Cmax (Nm) (2)
PTO ratio
2830.5
2835.6
Left-hand side Rear Clockwise 120 1.00
2840.6
2850.6
6AS400
Left-hand side Rear Clockwise 180 1.04
(1) With respect to forward direction of travel.
(2) When viewing the PTO output from the front.
(3) The maximum torque that can be taken refers to an engine speed of 1,500 r.p.m. output from the PTO For higher speeds, the value for the torque that can
be taken must be reduced proportionally.
IVECO reserves the right not to honour any guarantees on the transmission where the malfunction
can be traced back to the PTO and, in this case, the PTO installed by the Bodybuilder has specifications
and performance different from those indicated in Table 4.1.
Figure 4.4
166656