imagistics DL650, Operating Manual

Page: 98 / 344

Lens Mode (continued)
6-18 Basic Operations
Basic Operations
Selecting a Special Ratio for Non-Standard Paper
To determine reduction or enlargement ratios when using non-standard paper sizes, refer
to the Special Ratio Table on the next page and follow the procedure below.
ORIGINAL-COPY WIDTH
FIRST, LOCATE THE ORIGINAL WIDTH ON THE HORIZONTAL AXIS.
THEN, LOCATE THE COPY WIDTH ON THE VERTICAL AXIS.
FIND THE RATIO ON THE TABLE WHERE THESE TWO VALUES MEET.
ORIGINAL-COPY LENGTH
FIRST, LOCATE THE ORIGINAL LENGTH ON THE HORIZONTAL AXIS.
THEN, LOCATE THE COPY LENGTH ON THE VERTICAL AXIS.
FIND THE RATIO ON THE TABLE WHERE THESE TWO VALUES MEET.
The ratio you use must fall within the available magnification range of 0.250~4.000. Use
the smaller ratio for reduction and use the larger ratio for enlargement.
Basic Screen with the popup menu for zoom setting
1 First, determine the correct ratio, as described above.
2 Touch
ZOOM on the Basic Screen to display the popup menu for setting the zoom ratio.
3 Use the keypad on the popup menu to enter the desired reduction or enlargement ratio
in 3 digits or use arrows to scroll to the desired ratio.
4 When the desired ratio is specified, touch
OK
to complete the setting.
To cancel the setting, touch ZOOM again, select the desired ratio, then touch OK .
5 Position original(s) FACE DOWN on the platen glass or FACE UP in the EDH, as
required.
6 When all other settings are acceptable, press [
Start
].
DL650us062v1.fm 18 ページ ２００１年１１月１４日 水曜日 午後３時０分