HNC Electric SV-E3 Series, Instruction Manual

Page: 122 / 178

122
Drive restriction is enabled 」. Initial value: 「1: Short brake」.
●After-stop state can be selected in parameter No.67.2 「Selection for Stop condition when
Drive restriction is enabled」. Initial value: 「0: Free-run」
●Parameter No.67.3 「Selection for Location deviation counter option when Drive restriction is
enabled」can be set to hold the position deviation counter. Initial value: 「0: Keep」
TLSEL1 Torque limit
●Torque limit switch.
●It is effective when 「1: Enable」 is selected in parameter No.144.0「Enable/Disable Torque
command limit Override」
●At open circuit, the parameter No.147.0「Torque command limit Override 1」is preferred. At
power On, the parameter No.148.0「Torque command limit Override 2」is preferred.
△ ○ ○
PCSTAR
T1
CW start
●It is effective when the parameter No.642.0 「Internal speed command - Operation mode」 is
set to “0=Point table”.
●When PCSEL1 to 4 is specified to point No. and connected to COM-, point table No. and home
position reset can execute.
△ - -
PCSEL1 Selection 1 of
point No.
●Specify the point No. and home position reset to be executed.
●According to the setting of parameter No.646.3 「Point No.0 function selection」, when
specifying the point No.0, you can select home position reset or point No..
Point No. PCSEL1 PCSEL2 PCSEL3 PCSEL4
0 or home
position reset
OFF OFF OFF OFF
1 ON OFF OFF OFF
2 OFF ON OFF OFF
3 ON ON OFF OFF
4 OFF OFF ON OFF
5 ON OFF ON OFF
6 OFF ON ON OFF
7 ON ON ON OFF
8 OFF OFF OFF ON
9 ON OFF OFF ON
10 OFF ON OFF ON
11 ON ON OFF ON
12 OFF OFF ON ON
13 ON OFF ON ON
14 OFF ON ON ON
15 ON ON ON ON
△ - -
PCSEL2 Selection 2 of
point No.
PCSEL3 Selection 3 of
point No.
PCSEL4 Selection 4 of
point No.
(HOME) N
ote 1)
Home position
reset start
●Start home position reset after connecting COM-.
△ - -
ORG Home position
sensor
●Home position reset with home position sensor, input the home position sensor signal.
△ - -