HNC Electric SV-E3 Series, Instruction Manual, Page: 107 / 178

107
Table 8.3.5 Analog speed command Speed limit value settings
Rotation direction Parameter No. Parameter Setting value
CCW 52.0 Analog speed command
CCW speed limit value(Numerator)
“3000”
53.0 Analog speed command
CCW speed limit value(Denominator)
“5000”
CW 54.0 Analog speed command
CW speed limit value(Numerator)
“3000”
55.0 Analog speed command
CW speed limit value(Denominator)
“5000”
Table 8.3.6 Parameter 62.0 settings and rotation direction of the motor (Analog speed command input)
Value of parameter 62.0 Input analog command
Positive voltage Negative voltage
0
1
[Initial value]
8.3.3 Test run (Analog speed command input)
■
Before test run
Table 8.3.7
Make sure all the wiring are connected properly before
switch on the power to the drive and motor.
To prevent electric shock, fire, malfunction and injury.
Test run after setting the basic parameters. If set the wrong basic parameters, the motor will not
run, run unsteadily or lose control, which may cause
some injury or accidents.
Confirm the operation of the motor alone first before test
run. (Remove the other connection to the mechanics.)
The unexpected movements, such as unstable action
or lose control, may cause tome injury or accidents.
Drive the motor after release the brake on the motor if
the motor is attached with the brake.
If not, it may cause the malfunction to the brake and
motor.
■
Test run
Table 8.3.8 Steps for test run (Analog speed command input)
Steps Operation
1 Make sure all the wiring are connected properly.
2 Switch on the power to the drive. Note 1)
3 Switch on the main circuit power to the drive(200V AC).
4 Connect SVON terminal of CN1 connector to COM- to make the servo ON.
5 Input the analog speed command voltage at a low voltage to make the motor run at a low speed.
6 Improve the position command pulse frequency gradually after confirming the safe implementation of