HNC Electric SV-E3 Series, Instruction Manual

Page: 78 / 178

78
Override
(Denominator/
Numerator)
[Setting range] 0 to 65535/1 to 65535
294. 0/
295. 0
[Basic setting]
Analog torque
command CW
torque limit
Override
Set Analog torque command CW torque limit Override
Analog command CW torque limit =motor peak torque × (Override
(Numerator)/Override(Denominator))
[Initial value] (Numerator) / (Denominator) = 3100/3100 (Varies with motor models)
[Setting range] 0 to 65535/1 to 65535
No
300. 0 [Basic setting]
Analog torque
command Fixed
offset value
Set Analog torque command Fixed offset value.
This parameter is valid when No.302.2 =1. If the input voltage is 0V, the state of analog
torque command input is 0%.
<Setting method>
1. Servo ON (The motor rotates automatically if offset deviation occurs)
2. Observe the torque command value, and set offset value.
[Initial value] 0
[Setting range] -32768 to 32767
No
302. 0 [Basic setting]
Analog torque
command
Rotation direction
Set Rotation direction of Analog torque command input.
0 = CCW rotation by negative input voltage
，
CW rotation by Positive input voltage
1 = CCW rotation by positive input voltage
，
CW rotation by negative input voltage
[Initial value] 1 (CCW rotation by positive input voltage)
[Setting range] 0 or 1
No
302. 1 [Basic setting]
Analog torque
command Input
filter option
Enable/Disable Input filter for Analog torque command. It can be done by No. 288. 0
and No. 289. 0.
0 = Disable
1 = Enable
[Initial value] 1
[Setting range] 0 or 1
No
302. 2 [Basic setting]
Analog torque
command Offset
adjustment
method
Select Offset adjustment method of Analog torque command.
Auto tuning is that the input voltage can make the torque command 0% at servo ON.
Manual tuning is to input offset value by manual to make torque command 0% at input
voltage 0V. Offset value can be adjusted by No.300.0 (Analog torque command Fixed
offset value)
0 = Auto tuning
1 = Manual tuning
[Initial value] 1 (Manual tuning)
[Setting range] 0 or 1
No
385. 0 [Basic setting]
JOG operation:
Acceleration time
Set Acceleration time for the JOG operation
This parameter set a duration for the speed command to accelerate from 0 rpm to
1000rpm.
[Initial value] 1000[ms]
[Setting range] 0 to 60000[ms]
No
386. 0 [Basic setting]
JOG operation:
Deceleration time
Set Deceleration time for the JOG operation
This parameter set a duration for the speed command to accelerate from 1000 rpm to
0rpm.
No